DESIGN OF PARALLEL COUPLED MICROSTRIP BAND-PASS FILTER

Authors

  • Ghasan Ali Hussain assist Lecturer in Electrical department - College of engineering / University of Kufa

DOI:

https://doi.org/10.24297/ijct.v15i5.1650

Keywords:

Band-Pass-Filters, Microstrip, Ansoft Designer, Transmission line, Fabricate

Abstract

Filters occupy important acts in several Radio Frequency microwave applications. Several applications such as wireless communications still challenge RF/microwave filters with strict requirements such as smaller size, higher performance, lighter weight, and lower cost. Microstrip Filters for RF/Microwave Applications offers a unique and comprehensive treatment of RF/microwave filters based on the microstrip structure. One of the most common methods in designing microwave filters is using of parallel-coupled microstrip. In this paper  simulate and fabricate by using Ansoft Designer a two resonator microstrip band-pass filter suitable for Wi-Fi applications.  The results of simulation were quite good.

Downloads

Download data is not yet available.

Author Biography

Ghasan Ali Hussain, assist Lecturer in Electrical department - College of engineering / University of Kufa

Assist Lecturer

Downloads

Published

2016-04-21

How to Cite

Hussain, G. A. (2016). DESIGN OF PARALLEL COUPLED MICROSTRIP BAND-PASS FILTER. INTERNATIONAL JOURNAL OF COMPUTERS &Amp; TECHNOLOGY, 15(5), 6768–6775. https://doi.org/10.24297/ijct.v15i5.1650

Issue

Section

Research Articles